Chapter 6 Monitor
USG20(W)-VPN Series User’s Guide
119
Model This field displays the AP’s hardware model information. It displays N/A (not applicable)
only when the AP disconnects from the USG and the information is unavailable as a
result.
MAC Address This field displays the MAC address of the AP.
Radio This field displays the Radio number. For example 1.
OP Mode This field displays the operating mode of the AP. It displays n/a for the profile for a radio
not using an AP profile.
AP Mode means the AP can receive connections from wireless clients and pass their data
traffic through to the USG to be managed (or subsequently passed on to an upstream
gateway for managing).
MON Mode means the AP monitors the broadcast area for other APs, then passes their
information on to the USG. If an AP is set to this mode it cannot receive connections from
wireless clients.
Profile This field displays the AP Profile for the Radio. It displays n/A for the radio profile not
using an AP profile. It displays default if using a default profile.
Frequency Band This field displays the WLAN frequency band using the IEEE 802.11 a/b/g/n/ac standard
of 2.4 or 5 GHz.
Channel ID This field displays the WLAN channels using the IEEE 802.11 protocols.
Tx Power This field displays the transmission power the USG is using.
Station This field displays the station count information.
Rx PKT This field displays the data packets of incoming traffic on the AP.
Tx PKT This field displays the data packet of outgoing traffic on the AP.
Rx FCS Error
Count
This field displays the erroneous data packet count received and detected by Frame
Check Sequence (FCS)
Tx Retry Count This field displays the data packet count that were transmitted for retry.
Table 46 Monitor > Wireless > Radio List
LABEL DESCRIPTION
To Next Page
Loading...
