Chapter 9 Interfaces
USG20(W)-VPN Series User’s Guide
181
Check Period Enter the number of seconds between connection check attempts.
Check Timeout Enter the number of seconds to wait for a response before the attempt is a failure.
Check Fail
Tolerance
Enter the number of consecutive failures before the USG stops routing through the
gateway.
Check Default
Gateway
Select this to use the default gateway for the connectivity check.
Check this
address
Select this to specify a domain name or IP address for the connectivity check. Enter
that domain name or IP address in the field next to it.
Check Port This field only displays when you set the Check Method to tcp. Specify the port
number to use for a TCP connectivity check.
Related Setting
Configure WAN
TRUNK
Click WAN TRUNK to go to a screen where you can configure the interface as part of
a WAN trunk for load balancing.
Configure Policy
Route
Click Policy Route to go to the policy route summary screen where you can configure
a policy route to override the default routing and SNAT behavior for the interface.
IP Address
Assignment
Get
Automatically
Select this option If your ISP did not assign you a fixed IP address. This is the default
selection.
Use Fixed IP
Address
Select this option If the ISP assigned a fixed IP address.
IP Address
Assignment
Enter the cellular interface’s WAN IP address in this field if you selected Use Fixed IP
Address.
Metric Enter the priority of the gateway (if any) on this interface. The USG decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the USG uses the one that was
configured first.
Device Settings
Band Selection This field appears if you selected a mobile broadband device that allows you to select
the type of network to use. Select the type of mobile broadband service for your
mobile broadband connection. If you are unsure what to select, check with your mobile
broadband service provider to find the mobile broadband service available to you in
your region.
Select auto to have the card connect to an available network. Choose this option if you
do not know what networks are available.
You may want to manually specify the type of network to use if you are charged
differently for different types of network or you only have one type of network
available to you.
Select GPRS / EDGE (GSM) only to have this interface only use a 2.5G or 2.75G
network (respectively). If you only have a GSM network available to you, you may
want to select this so the USG does not spend time looking for a WCDMA network.
Select UMTS / HSDPA (WCDMA) only to have this interface only use a 3G or 3.5G
network (respectively). You may want to do this if you want to make sure the interface
does not use the GSM network.
Select LTE only to have this interface only use a 4G LTE network. This option only
appears when a USB dongle for 4G technology is inserted.
Table 72 Configuration > Network > Interface > Cellular > Add / Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
