Chapter 9 Interfaces
USG20(W)-VPN Series User’s Guide
187
Figure 135 Network > Interface > Tunnel > Add/Edit
Each field is explained in the following table.
Table 74 Network > Interface > Tunnel > Add/Edit
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
General Settings
Enable Select this to enable this interface. Clear this to disable this interface.
Interface Properties
Interface Name This field is read-only if you are editing an existing tunnel interface. Enter the name of
the tunnel interface. The format is tunnelx, where x is 0 - 3. For example, tunnel0.
Zone Use this field to select the zone to which this interface belongs. This controls what
security settings the USG applies to this interface.
To Next Page
Loading...
