Chapter 1 Introduction
USG20(W)-VPN Series User’s Guide
22
Web Configurator
The Web Configurator allows easy USG setup and management using an Internet browser. This
User’s Guide provides information about the Web Configurator.
Figure 7 Managing the USG: Web Configurator
Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the USG. Access it using remote
management (for example, SSH or Telnet) or via the physical or Web Configurator console port.
See the Command Reference Guide for CLI details. The default settings for the console port are:
FTP
Use File Transfer Protocol for firmware upgrades and configuration backup/restore.
SNMP
The device can be monitored and/or managed by an SNMP manager. See Section 30.11 on page
577.
Table 2 Console Port Default Settings
SETTING VALUE
Speed 115200 bps
Data Bits 8
Parity None
Stop Bit 1
Flow Control Off
To Next Page
Loading...
