Chapter 26 BWM (Bandwidth Management)
USG20(W)-VPN Series User’s Guide
415
Figure 287 Configuration > BWM > Create New Object > Add Address
The following table describes the fields in the above screen.
Table 162 Configuration > BWM > Create New Object > Add Address
LABEL DESCRIPTION
Name Enter a name for the Address object of the rule.
Address Type Select an Address Type from the drop down menu on the right. The Address
Types are Host, Range, Subnet, Interface IP, Interface Subnet, and Interface
Gateway.
IP Address Enter an IP address for the Address object.
OK Click OK to save the setting.
Cancel Click Cancel to abandon the setting.
To Next Page
Loading...
