Chapter 29 Object
USG20(W)-VPN Series User’s Guide
465
29.2.4.1 Default User Authentication Timeout Settings Edit Screens
The Default Authentication Timeout Settings Edit screen allows you to set the default
authentication timeout settings for the selected type of user account. These default authentication
timeout settings also control the settings for any existing user accounts that are set to use the
default settings. You can still manually configure any user account’s authentication timeout
settings.
To access this screen, go to the Configuration > Object > User/Group > Setting screen (see
Section 29.2.4 on page 462), and click one of the Default Authentication Timeout Settings
section’s Edit icons.
Figure 312 Configuration > Object > User/Group > Setting > Edit
User Lockout Settings
Enable logon retry limit Select this check box to set a limit on the number of times each user can
login unsuccessfully (for example, wrong password) before the IP address is
locked out for a specified amount of time.
Maximum retry count This field is effective when Enable logon retry limit is checked. Type the
maximum number of times each user can login unsuccessfully before the IP
address is locked out for the specified lockout period. The number must be
between 1 and 99.
Lockout period This field is effective when Enable logon retry limit is checked. Type the
number of minutes the user must wait to try to login again, if logon retry
limit is enabled and the maximum retry count is reached. This number
must be between 1 and 65,535 (about 45.5 days).
Apply Click Apply to save the changes.
Reset Click Reset to return the screen to its last-saved settings.
Table 183 Configuration > Object > User/Group > Setting (continued)
LABEL DESCRIPTION
To Next Page
Loading...
