Chapter 29 Object
USG20(W)-VPN Series User’s Guide
487
Figure 327 Configuration > Object > MON Profile > Add/Edit MON Profile
The following table describes the labels in this screen.
Table 198 Configuration > Object > MON Profile > Add/Edit MON Profile
LABEL DESCRIPTION
Activate Select this to activate this monitor mode profile.
Profile Name This field indicates the name assigned to the monitor mode profile.
Channel dwell time Enter the interval (in milliseconds) before the AP switches to another channel for
monitoring.
Scan Channel Mode Select auto to have the AP switch to the next sequential channel once the Channel
dwell time expires.
Select manual to set specific channels through which to cycle sequentially when the
Channel dwell time expires. Selecting this options makes the Scan Channel List
options available.
Country Code Select the country where the USG is located/installed.
The available channels vary depending on the country you selected. Be sure to select
the correct/same country for both radios on an AP and all connected APs, in order to
prevent roaming failure and interference to other systems.
To Next Page
Loading...
