Chapter 29 Object
USG20(W)-VPN Series User’s Guide
494
To access this screen, log in to the Web Configurator, and click Configuration > Object > Service
> Service. Click a column’s heading cell to sort the table entries by that column’s criteria. Click the
heading cell again to reverse the sort order.
Figure 332 Configuration > Object > Service > Service
The following table describes the labels in this screen.
29.6.2.1 The Service Add/Edit Screen
The Service Add/Edit screen allows you to create a new service or edit an existing one. To access
this screen, go to the Service screen (see Section 29.6.2 on page 493), and click either the Add
icon or an Edit icon.
Figure 333 Configuration > Object > Service > Service > Edit
Table 203 Configuration > Object > Service > Service
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The USG confirms you want to remove it
before doing so.
Object
References
Select an entry and click Object References to open a screen that shows which settings
use the entry.
# This field is a sequential value, and it is not associated with a specific service.
Name This field displays the name of each service.
Content This field displays a description of each service.
Reference This displays the number of times an object reference is used in a profile.
To Next Page
Loading...
