Chapter 30 System
USG20(W)-VPN Series User’s Guide
585
You must configure Configuration > System > CloudCNM to allow the USG to find the CloudCNM
server.
Figure 413 Configuration > System > CloudCNM
The following table describes the labels in this screen.
Note: See the CloudCNM User Guide for more information on CloudCNM.
Table 251 Configuration > System > CloudCNM
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
Enable Select this to allow management of the USG by CloudCNM.
Auto Select this if your CloudCNM server can access MyZyXEL.com and you have a CNM
ID from the CloudCNM license.
CNM ID Enter the CNM ID exactly as on the CloudCNM license.
CNM URL MyZyXEL.com associates the CNM ID with the CNM URL which identifies the server
on which CloudCNM is installed. Therefore you don’t need to enter the CNM URL when
you select Auto.
Custom Select this if your CloudCNM server cannot access MyZyXEL.com.
CNM URL If your USG server cannot access MyZyXEL.com, then select Custom and enter the
IPv4 IP address of the CloudCNM server followed by the port number (default 7547
for HTTPS or 7549 for HTPP) in CNM URL. For example, if you installed CloudCNM on
a server with IP address 1.1.1.1, then enter 1.1.1.1:7547 or 1.1.1.1:7549 as the
CNM URL.
Transfer Protocol Choose the CNM URL protocol: HTTP or HTTPS. If you enter 1.1.1.1:7547 as the
CNM URL, you must choose HTTPS as the Transfer Protocol, and then the whole
CNM URL is https://1.1.1.1:7547. If you enter 1.1.1.1:7549 as the CNM URL, you
must choose HTTP as the Transfer Protocol, and then the whole CNM URL is http:/
/1.1.1.1:7549.
Periodic Inform Enable this to have the USG inform the CloudCNM server of its presence at regular
intervals.
Interval Type how often the USG should inform CloudCNM server of its presence.
Apply Click Apply to save your changes back to the USG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
