ZyXEL Communications ZyWall USG20-VPN - Page 602

Chapter 31 Log and Report
USG20(W)-VPN Series User’s Guide
602
Figure 424 Log Category Settings AC
This screen provides a different view and a different way of indicating which messages are included
in each log and each alert. Please see Section 31.3.2 on page 594, where this process is discussed.
(The Default category includes debugging messages generated by open source software.)
The following table describes the fields in this screen.
Table 262 Configuration > Log & Report > Log Setting > Log Category Settings
LABEL DESCRIPTION
System Log Use the System Log drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not log any information for any category for the system log or
e-mail any logs to e-mail server 1 or 2.
enable normal logs (green check mark) - create log messages and alerts for all categories
for the system log. If e-mail server 1 or 2 also has normal logs enabled, the USG will e-mail
logs to them.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts,
and debugging information for all categories. The USG does not e-mail debugging
information, even if this setting is selected.
USB Storage Use the USB Storage drop-down list to change the log settings for saving logs to a
connected USB storage device.
disable all logs (red X) - do not log any information for any category to a connected USB
storage device.
enable normal logs (green check mark) - create log messages and alerts for all categories
and save them to a connected USB storage device.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts,
and debugging information for all categories and save them to a connected USB storage
device.