Chapter 32 File Manager
USG20(W)-VPN Series User’s Guide
612
Figure 430 Maintenance > File Manager > Firmware Package
The following table describes the labels in this screen.
Table 265 Maintenance > File Manager > Firmware Package
LABEL DESCRIPTION
Firmware Status
Reboot Now Click the Reboot Now button to restart the USG. If you applied changes in the Web
configurator, these were saved automatically and do not change when you reboot. If you
made changes in the CLI, however, you have to use the write command to save the
configuration before you reboot. Otherwise, the changes are lost when you reboot.
If you want the Standby firmware to be the Running firmware, then select the Standby
firmware row and click Reboot Now. Wait a few minutes until the login screen appears.
If the login screen does not appear, clear your browser cache and refresh the screen or
type the IP address of the USG in your Web browser again.
You can also use the CLI command reboot to restart the USG.
# This displays the system space (partition) index number where the firmwarm is located.
The firmware can be either Standby or Running; only one firmware can be running at
any one time.
Status This indicates whether the firmware is Running, or not running but already uploaded to
the USG and is on Standby. It displays N/A if there is no firmware uploaded to that
system space.
Model This is the model name of the device which the firmware is running on.
Version This is the firmware version and the date created.
Released Date This is the date that the version of the firmware was created.
Upload File
To upload image
file in system
space
Click the To upload image file in system space pull-down menu and select 1 or 2. The
default is the Standby system space, so if you want to upload new firmware to be the
Running firmware, then select the correct system space.
Boot Options If you upload firmware to the Running system space, the USG will reboot automatically.
If you upload firmware to the Standby system space, you have the option to Reboot
now or Don’t Reboot.
Reboot now If you select Reboot now, then the firmware upload to Standby system space will
become the Running firmware after you click Upload and the upload process completes.
To Next Page
Loading...
