Using DECT Handsets with Your Phone
179
The phone is during a call, and the satellite mode is selected as Take over call. And make sure there is only one
call on the phone.
Procedure
1. Swipe the soft key area left and then tap Call Shift.
The call is automatically connected on the handset.
Related Topic
Selecting a Handset to Use the Satellite Mode
Pull an Active Call from the Handset
You can retrieve the call from the handset to the phone after off-hook.
Before You Begin
The handset is during a call, and the satellite mode is selected as Take over call. And make sure there is only one
call on the handset.
Procedure
1.
Do one of the following:
l Pick up the handset.
l Press the Speakerphone key .
l
Select the line key, and then select Call Pull.
The call is connected to the phone.
Related Topic
Selecting a Handset to Use the Satellite Mode
Shared Directory
Users can manage contacts and use them on the phone and all registered handsets. You can store up to 1000 con-
tacts in your phone’s shared directory.
Check with your system administrator to find out if this feature is available on your phone.
Note: For more information on how to bind a handset, refer to Selecting a Handset to Use the Satellite Mode.
Topics
Adding Shared Contacts
Viewing Shared Contacts
Editing Shared Contacts
Deleting a Shared Contact
Deleting All Shared Contacts
Searching for Shared Directory Contacts
Moving a Shared Contact to the Blocklist Directory
Saving a Shared Contact to the Local Directory
Placing a Call from the Shared Directory
Adding Shared Contacts
When you add a contact to your Shared Directory, you can set the desired information for your contact. You are
required to enter a contact name at least for each new contact.
Procedure
To Next Page
Loading...