142 APPENDIX B: CONFIGURATION APPLICATION
Figure 14 Download Software Update Menu with IP Address and Filename
3 Enter 3 to download the application image and load it into the
non-volatile storage on the Layer 3 Module.
The following prompt is displayed:
Enter one of: 1 2 3 4 0? 3
Starting tftp download. Please wait a few
moments..................................
............................................................
Image read done, 4458064 bytes OK
If the image loaded into the Layer 3 Module is corrupt, you receive an
error message, similar to the following:
This image has an invalid checksum
This may be because the image was not transferred in binary mode when
FTPed between hosts.
CAUTION: During the programming of the application image, you must
not do any of the following:
■ Power down and power up the Switch.
■ Reset the Switch.
■ Close the Telnet session to the Configuration Application.
These actions prevent the application image from being loaded into the
Layer 3 Module.
To Next Page
Loading...
