48 CHAPTER 6: SETTING SNMP AND SYSTEM PARAMETERS
Available System
Context Commands
The following commands are available in the system context:
Displaying the
System
Configuration
The system configuration display provides software and hardware
revisions, module status information, and warning messages for certain
system conditions.
To display the system configuration, enter the following at the top-level
menu:
system display
The display contains the following general system information:
■ The system name
■ The system ID
■ The software version, build date, and time
Table 14 System Context Commands
Command Options Syntax
display Display the configuration of the Layer 3 Module
softwareUpgrade Initiate a TFTP download of new system software
initialize Reset nonvolatile data to factory defaults
consoleTimeout timeout Enable/disable the console inactivity time-out
interval Set the console inactivity time-out (in minutes)
password Change password for browsing or viewing,
configuring network parameters, or for full system
administration
name Assign an easily recognizable and unique name to the
Layer 3 Module
nvData save Save nonvolatile data
restore Restore nonvolatile data
reset Reboot the system
To Next Page
Loading...
Need help?
General