46 CHAPTER 6: SETTING SNMP AND SYSTEM PARAMETERS
Enter new read-only community [public]:
Enter new read-write community [private]: secret
You can only change the community strings if you are logged into the
user interface as administrator.
Administering
SNMP Trap
Reporting
For network management applications, you can manually administer the
trap reporting address information.
Displaying Trap
Reporting
Information
To display trap reporting information, including the various SNMP traps
and their current configured destinations, enter the following at the
top-level menu:
snmp trap display
The following example shows a trap settings display:
Configuring Trap
Reporting
You can define up to 10 destination addresses and modify the set of traps
that are sent to each destination address.
To configure trap reporting:
1 Enter the following at the top-level menu:
snmp trap addModify
The following prompt is displayed:
Enter the trap destination address:
2 Enter the IP address of the SNMP manager (destination address).
Enter the trap numbers to enable (1-4|all) [all]:
3 Enter one or more trap numbers or all for that destination.
Separate a series of more than two trap numbers with a hyphen (-) and
nonsequential trap numbers by commas.
To Next Page
Loading...
Need help?
General