88 CHAPTER 8: SETTING IP PARAMETERS
Displaying the
Default Route Metric
To display the current default route metric value, enter the following at
the top-level menu:
ip ospf defaultRouteMetric display
The default route metric is displayed:
Default route metric = 1
Defining the Default
Route Metric
To define a default route metric for the router:
1 Enter the following at the top-level menu:
ip ospf defaultRouteMetric define
The following prompt is displayed:
Default route metric (1-65535) [1]:
2 Enter the default route metric value at the prompt.
Removing a Default
Route Metric
To remove a default route metric from the Layer 3 Module, enter the
following at the top-level menu:
ip ospf defaultRouteMetric remove
The designated default route metric is removed immediately.
Configuring OSPF
Interfaces
This section describes how to configure OSPF interfaces by adding OSPF
characteristics to existing IP Virtual LAN (VLAN) interfaces. You can
configure the following OSPF characteristics on existing IP VLAN
interfaces:
■ Mode
■ Priority
■ Area ID
■ Cost
■ Transmit delay
■ Hello timer
■ Retransmit timer
■ Dead interval
■ Password
To Next Page
Loading...
