Administering UDP Helper 75
The following example shows a UDP Helper display:
Defining a Port and
an IP Forwarding
Address
You can define port numbers and IP forwarding addresses for the UDP
Helper. You may have up to 32 combinations of port numbers and IP
forwarding addresses per router. You may also have multiple IP address
entries for the same ports.
To define a port and IP forwarding address:
1 Enter the following at the top-level menu:
ip udpHelper define
The following prompt is displayed:
Enter UDP port number (1-65535)[67]:
2 Enter the UDP port number.
Enter forwarding IP address:
3 Enter the forwarding address.
Removing a Port or
an IP Forwarding
Address
You can remove a port number or IP forwarding address defined for UDP
Helper.
To remove a port or IP forwarding address:
1 Enter the following at the top-level menu:
ip udpHelper remove
The following prompt is displayed:
Enter UDP port number (1-65535):
2 Enter the UDP port number that you want to remove.
Enter forwarding IP address:
3 Enter the IP forwarding address that you want to remove. The Layer 3
Module removes the port numbers and IP forwarding addresses you
specified immediately.
To Next Page
Loading...
Need help?
General