113
Use the [Up] and [Down] keys to select Loss or
Noise/Longitudinal Balance setup and press the
[Setup] key.
The Noise/Longitudinal Balance setup screen is
identical to the screen above, except for the heading.
Press the [Tab] key to select the parameter to edit. For
the dial type and start type selections, use the [Up]
and [Down] keys to select DTMF or Pulse dialing,
Loop or Ground Start. If the test line number is
selected, press the [Setup] key to enter or change the
number.
Use the blue keys to enter a number. Press [Enter] to
accept the entry and return to the previous screen.
Press the [Setup] key to change the Active pair
parameters.
To Next Page
Loading...
Need help?
General
