67
Press the [Tab] key to display the results in ohms.
Press the [Enter] key to retest the same pair or the
[Return] key to test a new pair.
RFL Multiple Results
There are two possible formats for displaying the
results of an RFL Multiple measurement:
1) The temperature is known. In this case the screen
will show the calculated Distance to Strap (the
sum of all sections) in the main result box and the
“Distance to Fault”on the left on the next line and
the “Distance Strap to Fault” on the right on the
same line. The screen also shows the number of the
faulted section at the lower right side of the screen.
To Next Page
Loading...
