18
Voltage Termination (supported countries only)
This option allows you to select the input impedance
of the 965DSP digital voltmeter. Press the [Setup]
key from the Welcome screen, use the [Down] arrow
key to scroll to Voltage Termination, and then press
the [Enter] key to select.
The input impedance of the internal 965DSP
voltmeter is normally 1Mohm. However, some
legacy systems use voltage measurement systems
with input impedances of 100Kohms. This option
is provided to maintain measurement compatibility
with those systems. Use the [Tab] key to select the
desired termination and [Enter] to select.
To Next Page
Loading...
