13
Autotest Limits
Use the Autotest setup to change the pass/fail
threshold values for the Inactive Pair, Active Pair
and Wideband Autotests.
Use the [Up] and [Down] keys to highlight the
desired Autotest parameters to modify. Press the
[Enter] key to select the highlighted choice or press
the [Setup] key to restore the factory default values
for the selected Autotest.
If Wideband is selected, a list of the available
wideband services is displayed. Use the [Up] and
[Down] keys to select the wideband service to
modify. Press the [Enter] key to select the
highlighted choice or press the [Setup] key to restore
the factory default values for the selected service.
To Next Page
Loading...
