Features and MenuCards Main Menu
112
6.2.7 MenuCard “Connections”
Note: The availability of the following features will depend
on the current call state of your telephone. These features are
also in the call-dependent MenuCards. Some entries in the
Connections
MenuCard are only shown when you pro-
gramme the function onto a function key (please refer also
to the chapter Programming Functions (Features) starting on
page 123).
MPSelect
6ƒConnections
, then …
select
1ƒCall pick-up
, followed by …
■
1ƒPick-up
: This accepts a call for another telephone in your pick-up group.
If the person called is a member of a user group for which pick-up protection is
active, you can not pick up calls to their number.
■
2ƒPick-up select…
: You can answer a call for any other telephone. To do
this, enter the call number of the other telephone. If the other terminal is
already in the call state (e. g. an answering machine is in announcement
mode), you pick up the call. The person for whom you pick up the call must
belong to a user group for which “Call seizure” authorisation is activated, oth-
erwise the “Pick-up selective” function can not be used.
If the person called is a member of a user group for which pick-up protection is
active, you can not pick up calls to their number.
■
3ƒUnpark call
: “Unparks” a previously “parked” caller (see also MenuCard
“Conversation” starting on page 59).
Select
2ƒDial
, followed by …
■
1ƒAnnouncement…
: After entering the call number, you can initiate an
announcement on another system telephone. Under
Dest.:
enter the call
number. Announcements can also be directed to call numbers at which several
callers can be reached (see also Announcements (with and without Intercom)
starting on page 70).
■
2ƒIntercom
: Use this function to initiate an announcement to a single
system terminal, The microphone of the system terminal will be switched on
To Next Page
Loading...
