Remote-controlled Functions Remote-Programmable Voicebox Configuration and Query
96
Using the call number reserved in the OpenCom 100 for remote control, you can
configure or delete call forwarding “Immediate” for your own call number from
a remote location. This remotely-programmed forwarding overwrites any other
existing call forwarding. Call forwarding “On Busy” and “After Delay” are not
affected. Incorrect or non-existent call numbers are rejected. Your authorisation is
checked in the same way as for call forwarding within the OpenCom 100.
A correct entry is confirmed with a positive acknowledgement signal, provided
the system administrator has not deactivated this function (in the Configurator,
PBX Configuration: System: Settings menu). The external call is subsequently
ended.
Note: The procedure is aborted if there is a pause of longer
than 60 seconds between the entry of two digits. With this
duration, remote-controlled functions using GSM cell phones
can also be realised.
5.3 Remote-Programmable Voicebox Configuration
and Query
If the system administrator has configured remote query authorisation for your
voicebox, you can query and configure your voicebox from an external telephone:
■ Using the call number of OpenVoice (this number is included in the incoming
call distribution) …
you dial the MSN or the system number assigned by the system administrator
to the internal number of OpenVoice.
■ Using your own call number (this number is included in the incoming call dis-
tribution, and you have activated call forwarding for this telephone to the
voicebox) …
you dial the MSN or the direct-dialling in number under which you can be
reached by external callers.
Z Enter the system PIN.
* Press the star key.
Z Enter your internal call number.
# Press the hash key.
To Next Page
Loading...
