Telephoning Accepting Calls
63
Note: You cannot forward an internal call number to a vir-
tual call number. The OpenCom 100 cannot carry out such a
double forwarding.
External calls with unknown call number
When you receive an external call where the caller indicates a different number
than the one actually being transmitted (CLIP no screening), your display will show
a “?” next to the call number. If the indicated call number is saved as a phonebook
entry, as usual, the name will be shown along with a question mark.
2.4.2 Automatic Call Connection
In certain operational modes (e. g. in hands-free operation or when making calls
with a headset), it can be useful to be able to accept subsequent calls automati-
cally. On your system telephone, you set the delay after which calls are automati-
cally connected in the
5 Auto call Answer.
sub-menu of the
Calls
MenuCard.
2.4.3 Calls During a Conversation
On the Same Call Key
or
g Press the call key to which the call is being signalled (hands-
free mode).
G You are speaking on the telephone, hear the call waiting
tone and see the call on your display.
g Press the call key assigned to the line on which you are
speaking. This puts your first call on hold and connects you
to the new caller.
T Press the disconnect key to end the current call.
g Press the call key again.
G You are now reconnected to the subscriber you put on hold.
To Next Page
Loading...
