Team Functions Programming the Call Keys
93
will only indicate calls by means of a visual signal, even if they are made from a
direct-call key.
6 Ring tone
: You can set the
Volume
and
Melody
for different types of
incoming calls (
1ƒExternal calls
,
2ƒInternal calls
,
3ƒVIP call
,
4ƒDoor call
)for each trunk key. Proceed as described in the section “2 Ring
Tone” on page 108.
5ƒCall wait. prot.
: While you are making a call, other calls for the call
number of this team key are not signalled by a call waiting tone (but at the team
keys of other terminals unless call waiting protection was programmed there). Use
the
On
/
Off
options to switch the call waiting protection function on or off.
4.2.3 MenuCard “Prog. busy key”
g
Long press the busy key, then select …
1 Modify text
: The text currently assigned to the key is shown on the display
of your telephone. To change the text, press
O. Delete the existing text with
the
C key and enter new text, if required. Press O and confirm this with
Save
. If you delete the text, only the key’s call number will be displayed.
4.2.4 Direct-call Key
When a direct-call key is long pressed, no MenuCard is displayed. A direct-call key
is configured exclusively via the Configurator of the OpenCom 100 Web console.
To Next Page
Loading...
