Telephoning Special Calls/Functions
70
2.6 Special Calls/Functions
2.6.1 Accepting an Appointment Call
You can save appointments with the menu item
3ƒAppointments
in the Men-
uCard
Messages
.
At the appropriate time, the appointment message appears on the display and
your telephone rings for one minute with the ringer volume steadily increasing.
Press the OK key
O once to switch the ringer signal off. Press O again to
acknowledge the display signal. If you lift the handset during an appointment call,
a special tone indicates that the ringer signal was an appointment call.
You can also end the appointment call with the
e key or by lifting the
handset. Elapsed and active appointment calls are displayed in the
Info
MenuCard.
2.6.2 Baby Call
You can save an internal or external call number in the menu item
4ƒBaby call
of the MenuCard
Protection
. If the menu item has been activated, this pro-
grammed call number is dialled when a specified period has expired (default
setting is five seconds after you have lifted the handset). If you begin dialling a call
number within the specified period, the baby call is cancelled. The baby call can
also be triggered by pressing the hands-free/open-listening key
L, a call key
g or the headset key K (requirement: the headset has to be turned on,
see page 109).
Your system administrator configures the baby call period from 0 to 20 seconds for
all subscribers on the OpenCom 100. Ask your administrator what the current
value is.
2.6.3 Announcements (with and without Intercom)
Announcements can only be made to system terminals. For you to be able to use
this function, the system administrator must set up the corresponding authori-
sation for you. Announcements can be set up on single or multiple system ter-
minals. The “Announcement” function is available in two versions.
To Next Page
Loading...
