ABB 800xA - 800 Xa History Server

800xA History Server Appendix A IP Address Change
128 2PAA107563-600 B
In IP_Address_of_DCN enter the new IP Address of DCN.
For example,
@echo "P_MYIPFORMAIN=192.168.0.1"
d. Save and close the document.
3. Activate the Post-Install script:
a. Open windows service control manager
from Control Panel > Systems
and Security > Administrative Tools > Services.
b. Navigate to RTDB-Scheduler X:\RTDBData Service (where X is the
database d
rive name).
c. Right-click and select Restart
to restart the RTDB-Scheduler service.
Verification:
1. After performing above the steps, open Vtr
in GUI. Navigate to Maintenance
> Basic > Database Nodes.
2. The Database Nodes entry in both DCN and in the History Server should
conta
in the updated IP address for the DCN.
3. The latest diagnostic log file in DCN:
%app_datapath%\diag\APP_PostInstall_HierarchicalCpmPlusKM_yyyy
-mm-dd.
log should contain an entry:
INFO: telling MAIN my new IP address "xxx", old was "xxx"
The Post-Install script in History Server side is activated automatically. It will use
the new IP address information of DCN, and configures the necessary files and
automatically restarts the corresponding services.
800xA History Server
Since the IP address of History Server must be given during DCN setup phase, the
situation when the IP address of History Server changes requires operation in all
DCN nodes.
For Standalone History Server, perform the following steps: