Program features 135
Diagnostics
Motor identification
The performance of vector control is based on an accurate motor model determined
during the motor start-up.
A motor Identification magnetization is automatically performed the first time the start
command is given. During this first start-up, the motor is magnetized at zero speed
for several seconds to allow the motor model to be created. This identification method
is suitable for most applications.
In demanding applications a separate Identification run (ID run) can be performed.
Settings
Parameter 9910 ID RUN
Actual signal Additional information
Groups 01 OPERATING DATA …
04 FAULT HISTORY
Lists of actual signals
To Next Page
Loading...
