ABB ACS355 - Diagnostics

Program features 167
 Diagnostics
1402/1403/1410 Sequence programming output through relay output RO 2…4.
With option MREL-01 only.
1501 Sequence programming output through AO
1601 Run enable activation/deactivation
1805 Sequence programming output through DO
Group 19 TIMER & COUNTER State change according to counter limit
Group 32 SUPERVISION Timed state change
2201…2207 Acceleration/deceleration and ramp time settings
Group 32 SUPERVISION Supervision settings
4010/4110/4210 Sequence programming output as PID reference signal
Group 84 SEQUENCE PROG Sequence programming settings
Actual signal Additional information
0167 Sequence programming status
0168 Sequence programming active state
0169 Current state time counter
0170 Analog output PID reference control values
0171 Executed sequence counter
Parameter Additional information