￭
Installing the module
Install the module as follows:
1. Push the module carefully into its bay.
2. Install the module retaining screws and torque them to 5 N·m (3.6 lbf·ft).
3. Connect the coolant pipes to the module. Tighten to 20 N·m (14.75 lbf·ft).
4. Connect the power and control cables to the module.
5. Fill up the cooling system. For instructions, see section Filling up and bleeding
the internal cooling circuit (page 118).
6. Install the support beam in front of the module.
Maintenance 103
To Next Page
Loading...
