ABB ACS880-1607LC - Removing the Module

1
2
3
4
a
b
c
Removing the module
1. Do the steps in section Electrical safety precautions (page 49).
2. Assemble the service platform delivered with the drive. Refer to section Assembling
the service platform (page 104).
3. Remove the shrouding in front of the module.
4. Remove the locking screws of the swing-out frame (if present) and open it.
5. Disconnect the wiring from the module and move it aside. Use cable ties to keep
the wiring out of the way.
Maintenance 105