ABB ACS880-1607LC - Converter Module Hardware; Frame R7 I; Module Layout; Coolant Connectors

Converter module hardware
￭
Frame R7i
Module layout
1
1
6
4
5
3
7
3
W
V
U
8
–
+
Handle1
Lifting eye, front2
Locking screw (for 6 mm hex key). Torque: 5 N·m (3.7 lbf·ft) maximum.3
Coolant out connector4
Coolant in connector5
Connectors X50, X52 and X53; fiber optic connectors; LEDs; auxiliary voltage selector X59.6
Lifting ring, rear7
Guide pin8
DC connection busbars. The busbars engage with the quick connectors of the installation frame.
+
–
AC connection busbars. The busbars engage with the quick connectors of the installation frame.
U
V
W
Coolant connectors
The coolant pipe inlet and outlet connectors are located at the bottom front and top
front of the module respectively. The connectors are for 16/13 millimeter PA (polyamide)
pipe.
24 Operation principle and hardware description