136 Technical data
Category C3
The drive complies with the standard with the following provisions:
1. The drive is equipped with filtering option +E200.
2. The motor and control cables are selected as specified in this manual.
1. The drive is installed according to the instructions given in this manual.
3. Motor cable length does not exceed 100 metres (328 ft).
WARNING! A drive of category C3 is not intended to be used on a low-voltage public
network which supplies domestic premises. Radio frequency interference is expected
if the drive is used on such a network.
Category C4
If the provisions under Category C3 cannot be met, the requirements of the standard
can be met as follows:
1. It is ensured that no excessive emission is propagated to neighboring low-voltage
networks. In some cases, the inherent suppression in transformers and cables is
sufficient. If in doubt, the supply transformer with static screening between the
primary and secondary windings can be used.
2. An EMC plan for preventing disturbances is drawn up for the installation. A
template is available from the local ABB representative.
Low voltage
Equipment
Low voltage
Equipment
Equipment
(victim)
Supply transformer
Medium voltage network
Static screen
Point of measurement
Drive
Neighbouring network
To Next Page
Loading...
