80 Electrical installation
Installing the power cable clamp plates
Two identical power cable clamp plates are included with the drive. The picture below
depicts a frame size R1 drive; the installation is similar with other frame sizes.
Note: Support the cables adequately within the installation enclosure, especially if not
using the cable clamps.
Frames R1 and R2: 1.5 N·m (13 lbf·in)
Frames R3 and R4: 3 N·m (25 lbf·in)
1.5 N·m (13 lbf·in)
To Next Page
Loading...
