ABB ACS880-M04 - Installing Drive to a DIN Installation Rail - Frames R1 and R2 Only; Installing Mains Choke; Installing EMC Filter; Installing Brake Resistor

Mechanical installation 53
 Installing drive to a DIN installation rail – Frames R1 and R2 only
1. Click the drive to the rail. To detach the drive, press the release lever on top of the
drive as shown in the figure.
2. Fasten the lower edge of the drive to the mounting base through the two fastening
points.
Installing mains choke
See chapter Mains chokes on page 155.
Installing EMC filter
See chapter EMC filters on page 159.
Installing brake resistor
See chapter Resistor braking on page 173.
1
2