Electrical installation 73
Electrical installation
Contents of this chapter
The chapter describes the electrical installation procedure of the drive.
WARNING! Only qualified electricians are allowed to do the work described in
this chapter. Follow the Safety instructions on page 13. If you ignore them,
injury or death, or damage to the equipment can occur.
Make sure that the drive is disconnected from the input power during
installation. If the drive is already connected to the input power, wait for
5 minutes after disconnecting the input power.
WARNING! Installation must always be designed and made according to
applicable local laws and regulations. ABB does not assume any liability
whatsoever for any installation that breaches the local laws and/or other regulations.
If recommendations given by ABB are not followed, the drive system may
experience problems that the warranty does not cover.
To Next Page
Loading...
