About the manual 25
If the drive is about to be connected to an IT
(ungrounded) system, disconnect the internal
varistors and EMC filters. Also note that using
an EMC filter is not allowed in an IT
(ungrounded) system.
Electrical safety in installation, start-up and
maintenance on page 15.
Checking the compatibility with IT
(ungrounded) and corner-grounded TN
systems on page 76.
Connect the power cables. Connecting the power cables on page 77.
Connect the control and the auxiliary control
cables.
Connecting the control unit on page 85.
For optional equipment:
Mains chokes on page 155.
EMC filters on page 159.
Resistor braking on page 173.
Manuals for any optional equipment
Check the installation. Installation checklist on page 99.
Commission the drive. Start-up on page 101.
Firmware manual [3AXD50000030629
(English)]
Commission the brake chopper if required. Resistor braking on page 173.
Operate the drive: start, stop, speed control
etc.
Firmware manual [3AXD50000030629
(English)]
Task Refer to
To Next Page
Loading...
