12
AWT210 | 2-WIRE CONDUCTIVITY, PH/ORP, PION TRANSMITTER | OI/AWT210-EN REV. C
…5 Mechanical installation
…Transmitter installation
Wall mounting
Referring to Figure 12:
1 Position the left- and right-hand mounting brackets A into
the recesses on the rear of the transmitter as shown and
secure with the bracket securing screws. Ensure the plastic
washers remain in the positions fitted.
2 Mark fixing centers B and drill suitable holes in the wall.
3 Secure the transmitter to the wall using 2 screws C in
each mounting bracket.
NOTICE
If the optional weathershield D is used, position it between
the transmitter and wall and pass 2 screws C through
fixing holes (both sides) in weathershield.
Dimensions in mm (in)
A
B
C
right hand bracket omitted
for clarity
62
(2.44)
152 (5.98)
Weathershield dimensions
Optional weathershield
209 (8.22)
175 (6.89)
200
(7.87)
Figure 12 Wall mounting the transmitter
To Next Page
Loading...
