ABB AWT210 - 10 Menu Overview; Ph Menus

24 AWT210 | 2-WIRE CONDUCTIVITY, PH/ORP, PION TRANSMITTER | OI/AWT210-EN REV. C
10 Menu overview
pH menus
Level pH
See 
Language
Measurement Type
• pH Sensor Type
 Isopotential Point
 Asym metric Potential
• PV Unit
• Valence
• Magnitude
• End Magnitude
• End mV
Temperature Units
Te m p. Co mp. Ty p e
• Manual Temperature
• Solution Coefcient
Operator page 1
See 
Automatic Buffer Cal.
PV Manual Cal
Temperature Cal
Hold Output (HART only)
• Auto Buffer Setup
 Temperature Compensation
Coefcient
 Buffer Type
 Buffer 1 Value
 Buffer 2 Value
 User Dened Buffer 1
 User Dened Buffer 2
Calibration Limits
Edit Calibratio n
Restore Defaults
See 
Measurement Type
• pH Sensor Type
 Isopotential Point
 Asym metric Potential
• PV Unit
• Valence
• Magnitude
• End Magnitude
• End mV
Temperature Units
Temperature Compensation Type
• Manual Temperature
• Solution Coefcient
Temperature Sensor Type
Detect Temperature Sensor
Security Setup
PDM Compatibility (HART only)
Reset to defaults
Operator Page 1
Operator Page 2
Contrast
Language
Level pH

Engineering Range Low
Engineering Range High
Damping
Fault Current (HART only)
Output Type (HART only)
Function Gen Table (HART only)
Trim 4mA (HART only)
Trim 20mA (HART only)
Loop Test (HART only)
Diagnostics
Exit
Menu
Select
Sensor Diagnostics
Reference Impedance Limit
Diagnostic Status
Communication
Exit
Menu
Sel6ect
HART version:
Device Address
HART Tag
HART Description
Message
Manuf. ID
Last Command
HART Revision
Resp. Preamble
Loop Current Mode
PA version:
Slave Address
Device Tag
Ident No. Selector
Manuf. ID
Device Type
PA Prole
Foundation Fieldbus version
Node Address
Device Tag
Manuf. ID
Device Type
Device Revision
Simulation
Device Info
Exit
Menu
Select
Sensor Type
Device Serial No.
Software Version
Easy Setup
Exit
Menu
Select
Exit
Menu
Select
Calibra te
Sensor Setup
Exit
Menu
Select
Device Setup
Exit
Menu
Select
Display
Menu
Exit
Select
Input/Output
Exit
Menu
Select