ABB AWT210 - 2-Electrode Conductivity Menus

AWT210 | 2-WIRE CONDUCTIVITY, PH/ORP, PION TRANSMITTER | OI/AWT210-EN REV. C
25

Level 
See 
Language
Measurement Type
Cell Co nstant
• Concentration Units
• Concentration Curve Name
Temperature Units
Operator page 1
See 
Conductivity Calibration
Concentration Calibration
Temperature Calibration
Hold Output (HART only)
Edit Calibratio n
Restore Defaults
See  
Measurement Type
Cell Co nstant
• Concentration Units
• Con d uctivity U nits
• Concentration Curve Name
 Concentration Curve Table
Temperature Units
Temperature Compensation Type
• Manual Temperature
• Auto Temperature Compensation
Option
 Temperature Compensation
Coefcient
 Pure H2O Type
 User Dened Temperature
Compensation Curve
Reference Temperature
Temperature Sensor Type
Detect Temperature Sensor
Security Setup
PDM Compatibility (HART only)
Reset to defaults
Operator Page 1
Operator Page 2
Contrast
Language
Level 

Engineering Range Low
Engineering Range High
Damping
Fault Current (HART only)
Output Type (HART only)
Function Gen Table (HART only)
Trim 4mA (HART only)
Trim 20mA (HART only)
Loop Test (HART only)
Diagnostics
Exit
Menu
Select
Sensor Diagnostics
Diagnostic Status
Communication
Exit
Menu
Select
HART version:
Device Address
HART Tag
HART Description
Message
Manuf. ID
Last Command
HART Revision
Resp. Preamble
Loop Current Mode
PA version:
Slave Address
Device Tag
Ident No. Selector
Manuf. ID
Device Type
PA Prole
Foundation Fieldbus version
Node Address
Device Tag
Manuf. ID
Device Type
Device Revision
Simulation
Device Info
Exit
Menu
Select
Sensor Type
Device Serial No.
Software Version
Easy Setup
Exit
Menu
Select
Exit
Menu
Select
Calibra te
Sensor Setup
Exit
Menu
Select
Device Setup
Exit
Menu
Select
Display
Menu
Exit
Select
Input/Output
Exit
Menu
Select