AWT210 | 2-WIRE CONDUCTIVITY, PH/ORP, PION TRANSMITTER | OI/AWT210-EN REV. C
39
Device Setup
Used to setup security parameters, set PDM compatibility (for HART-enable transmitters) and to
reset default (factory-set) parameters.
Menu
Comment Default
Security Setup
HW Write Prot. Read-only.
Disabled/Enabled
SW Write Prot. Disabled/Enabled
Calibrate Password Available only at Advanced access level.
Advanced Password Available only at Advanced access level.
HART Login Enabled for HART versions only.
Disabled/Enabled
PDM Compatibility Available for HART versions only.
Enable this option if the device is connected to Siemens Simatic PDM.
Disabled/Enabled
Reset To Defaults Available only at Advanced access level.
Display
Used to setup Operator pages (1, 2), select the display language and set the display contrast.
Menu
Comment Default
PV/PV + Temperature/PV + Temp + PV%/PV + Temp + O/P
PV/PV + Temperature/PV + Temp + PV%/PV + Temp + O/P
Contrast Adjust contrast of display.
Language Selects the language to be displayed on screen:
English/Deutsch/Français/Español/Italiano
Note. Language options are displayed with localized spelling.
Device Setup
Exit
Menu
Select
Display
Exit
Menu
Select
To Next Page
Loading...
