ABB AWT210 - Overview; Name Plate;Certification Label; Transmitters Without Hazardous Area Approval; Transmitters with FM;CSA Approval and ATEX Iecex

6 AWT210 | 2-WIRE CONDUCTIVITY, PH/ORP, PION TRANSMITTER | OI/AWT210-EN REV. C
3 Overview

Figure 1 AWT210 transmitter – main components
Name plate/certification label
The following name plates are examples only. The name
plates attached to the transmitter may be different.
Transmitters without hazardous area approval
2809
Transmitters with FM/CSA approval and ATEX IECEx
Aluminium enclosure
APPROVED
US
C
IS : Class I Div 1 ABCD T4,
Class II Div 1 EFG T4
-25
C
≤ Ta ≤
+60 C
Exia
NI: Class 1 Div 2 Gps ABCD
Class II Div 2 Gps FG
Class III
-25 C
≤ Ta ≤
+60 C
FM18US0040X FM18CA0019X
USA: AWT200030 & AWT200031
Canada: AWT200032 & AWT200033
II 1 G Ex ia IIC T4 Ga
-20
C
≤ Ta ≤
+60 C
IP66
FM18ATEX0017X
IECEx FME 18.0001X
Installation drg
AWT2100034
0.56nF Li = 3.3mH
WARNING: SUBSTITUTION OF COMPONENTS
MAY IMPAIR INTRINSIC SAFETY.
AVERTISSEMENT: LA SUBSTITUTION DE
COMPOSANTS PEUT NUIRE À LA SÉCURITÉ
INTRINSÈQUE.
Transmitters with FM/CSA approval and ATEX IECEx
Plastic enclosure
II 1 G Ex ia IIC T4 Ga
-20
C
≤ Ta ≤
+60 C
IP66
FM18ATEX0017X
IECEx FME 18.0001X
Installation drg
AWT200034
IS : Class I Div 1 ABCD T4,
Class II Div 1 EFG T4
-25
C
≤ Ta ≤
+60
C
Exia
FM18US0040X FM18CA0019X
Installation drg:
USA: AWT200030
Canada: AWT200032
FM
0.56nF Li = 3.3mH
WARNING: SUBSTITUTION OF COMPONENTS
MAY IMPAIR INTRINSIC SAFETY.
AVERTISSEMENT: LA SUBSTITUTION DE
COMPOSANTS PEUT NUIRE À LA SÉCURITÉ
INTRINSÈQUE.
Wall mounting
bracket*
Display
Keypad
ON
OFF
Factory reset
switch
Communications module
Transmitter
door lock
Write protect
switch
Sensor module
Tamper-evident seal
attachment point