ABB AWT210 - Diagnostics

40
AWT210 | 2-WIRE CONDUCTIVITY, PH/ORP, PION TRANSMITTER | OI/AWT210-EN REV. C
…11 Configuration
Input/Output
Used to configure input/output values.
Menu
Comment Default
Eng. Low Measurement Type = Ion Concentration.
Conductivity devices cannot be edited if Measurement Type = Concentration.
See Easy Setup () or Sensor Setup () levels for the associated sensor type.
Eng. High Measurement Type = Ion Concentration.
Conductivity devices cannot be edited if Measurement Type = Concentration.
See Easy Setup () or Sensor Setup () levels for the associated sensor type.
Damping
Fault Current HART only.
High/Low
Output Type HART only.
Linear/Function-Generator
 HART only.
Enabled only if Output Type = Function-Generator.
X1/Y1/X2/Y2/X3/Y3/X4/Y4/X5/Y5/Table Error
None
Not Saved
 HART only.
Not available if HART in multidrop or fixed output mode.
 HART only.
Not available if HART in multidrop or fixed output mode.
Loop Test HART only.
Not available if HART in multidrop or fixed output mode.
Diagnostics
See page 21 for all diagnostic messages/actions.
Menu
Comment Default
Sensor Diagnostics 
Disabled/Enabled
Reference Imp. Limit pH only. Enabled only if Sensor Diagnostics = Enabled.
Disabled/Enabled
Diagnosis Status Read-only.
Actual/Simulated
Input/Output
Exit
Menu
Select
Diagnostics
Exit
Menu
Select