ABB COMMANDER C355 - A5 Cascade Controllers (Templates 11 and 12)

119
APPENDIX A – CONTROL TEMPLATES…
A3 Indicator/Manual Loader Station (Templates 7 and 8)
PV1
PV2
ao1
•1 Template 8 Only
•1
•2 Not applicable if Control Output Type is set to 'None' –
see Section 4.2/Basic Configuration.
•2
Manual Output
I/P2
I/P1
The Indicator/manual Loader Station is used to display one or two process variables on the digital and bargraph displays. If the control output is
assigned to an analog output, the lower display indicates its value which can be adjusted by the user. This output can be used
to manually control a process
or to provide a set point value for another controller.