89
0
A.PA5
b.07
0
C.PA5
b.11
0
S.PAS
b.10
•1
b.08
0
P.PAS
b.09
0
0.PAS
•2
•2
b.07...b.11
5 CONFIGURATION MODE…
…5.7 Level B – Operator Configuration
Auto-tune Password
Enables access to the auto-tune facility in the operator level.
[0 to 9999 (default 0)]
Profile Operator Password
Note. This frame is applicable only to software at issue 4 and later.
Enables access to the profile states level (level P) and the autotune
facility.
[0 to 9999 (default 0)]
Profile Configuration Password
Note. This frame is applicable only to software at issue 4 and later.
Enables access to the profile states, profile control and profile program
levels (levels P, r and t) and the autotune facility.
[0 to 9999 (default 0)]
Set Up Password
Enables access to the set up levels (levels 2, 3, 4 and 5) and the auto-
tune facility.
[0 to 9999 (default 0)]
Configuration Password
Enables access to the configuration levels, set up levels and the
autotune facility.
[0 to 9999 (default 0)]
Continued…
•1 Not displayed on Indicator or Auto/manual station templates.
•2 Displayed only if Ramp/Soak enabled – see Section 5.5, Set Point Configuration/ Ramp/Soak Enable.
To Next Page
Loading...
