ABB COMMANDER C355 - Level C - Output Assignment Configuration

91
ASSn
LEV.C
C.00
ANLG
tYP.1
C.01
dIG
or
AN1.A
NONE
dG1.A
NONE
•1
5.8 Level C – Output Assignment Configuration
Note. The Output Assignment default settings are preconfigured to each template – see Table B, Output
Sources on the rear fold-out.
Level C – Output Assignment
Note. To select this frame from anywhere in this page, press and
hold the
key for a few seconds.
Analog/Digital Output 1 (ao1/do1) Type
Select the output type for Output 1.
ANLG – Analog
dIG – Digital
Press
to advance to Analog Output 1 Assignment Source.
Press
to advance to Digital Output 1 Assignment Source.
Continued…
C.00, C01
5 CONFIGURATION MODE…
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 5.2, Basic Configuration/Control Output Type.