ABB COMMANDER C355 - Profile States

48
Pr.St
LEVP
P.00
NO
rSEt
P.03
xxxx
P.02
1
PrGM
P.01
SKP.x
SG.xx
P.04
LEVP
Pr.St
Lower display
left blank
rUN
or
H0Ld
SKP.F
or
SKP.b
Current
Profile
Status =
E or S
P.02
YES
•2
•2
SKPN
•1
P.00
P.00...P.04
…3 PROFILES
3.3 Profile States
•1 Displayed only if the current profile status is Stopped.
•2 Not displayed if the current profile state is Stopped or End.
Level P – Profile States
Program Select
Select the program to be run.
Note. This frame is displayed only if no other program is running.
[1 to 9]
Run/Hold Action
[
xxxx = current profile status: rUN – running, StOP – stopped, ENd –
end,
O.HLd – operator hold, _.HLd – manual hold, H.HLd – holdback hold]
rUN – Starts the selected program.
HOLd – Activates the Operator Hold.
Note. If a digital input assigned to the run/hold function has been
used to run a program, the user is prevented from activating the operator
hold.
Profile Reset
Select
YES to restart the profile at the beginning of the program.
YES – restart the profile
NO – do not restart the profile
Note. To end a program, select HOLd at the Profile Status frame
(see above) and then select
YES at this frame. The local set point value
takes the value of the first level of the selected program and the profile
status reverts to '
StOP'.
Skip Segment
The current segment number (or
NN) is shown in the upper display.
SKP.F + Skip Forward – abandon current segment and start the
next segment.
SKP.N Do Not Skip – maintain control using current segment.
SKP.b + Skip Back – return to beginning of current segment.
Return to top of Page