EasyManua.ls Logo

ABB COMMANDER C355 - Appendix B - Commander Configuration Editor

ABB COMMANDER C355
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
125
APPENDIX B COMMANDER CONFIGURATION EDITOR
B1 Introduction
Using the COMMANDER Configurator the COMMANDER 350 can be programmed without using any of the front
panel keys.
In addition to the standard settings, the Configurator also gives access to more advanced features not accessible
via the front panel keys. These are summarized below.
For information on using individual features, refer to the on-line help facility.
Note. The instrument must be in Configuration Mode (Level 6 or above) and Modbus serial
communications must be disabled when uploading or downloading from the PC Configurator.
B2 Analog Input Customization
Custom mA, mV, Voltage and Resistance ranges
Standard Linearizers can be assigned to electrical inputs (eg. allowing transmitter inputs to have
thermocouple or resistance linearizers to be applied)
Programmable fault detection levels (default = 10%)
B3 Four Programmable Math Blocks
One of seven types can be assigned to each math block:
citemhtirAdradnatS ehthtiw,kcolbhcaenidenibmocebnacsrotarepo3dnasdnarepo4otpU
.yllaitneuqesdetaluclacgniebsdnarepo
:srotarepO,tceleswol,tceleshgih,ylpitlum,edivid,tcartbus,dda
tcelesnaidem
:sdnarepOslangislatigidrogolanayna
)'0'ro'1'eulavehtevahslangislatigid(
egarevA latigidybteser,doirepemitelbatcelesarevolangisgolananafoeulavegarevaehT
langis
noitcetedmumixaM langislatigidybteser,langisgolananafoeulavmumixamehT
noitcetedmuminiM langislatigidybteser,langisgolananafoeulavmuminimehT
ytidimuhevitaleR srosneserutarepmetblubyrddnatewmorfdetaluclaC
toorerauqS langisgolanaynafoeulavtoorerauqsehT
rexelpitlumtupnI langislatigidagnisuselbairavgolanaowtroenofonoitceleS
stnemelE
noitauqerep51otpU
srotarepO ROXE,TON,DNAN,RON,DNA,RO:noitauqerep7otpU
sdnarepO
.langislatigidyna:noitauqerep8otpU
.slangislatigidtrevniotdesuebnacrotarepoTONehT
B4 Six Logic Equations
B5 Process Alarm Customization
Time Hysteresis, 0 to 9999 seconds
Alarm Disable Source
B6 Two Real-time Alarms
Programmable ON days, hours, minutes and duration (00:00 to 23:59)
Wildcard (*) to allow operation every
x
minutes past the hour

Table of Contents

Related product manuals