126
B7 Two Delay Timers
• Programmable delay and duration (0 to 9999 seconds)
B8 Two Custom Linearizers
• 15 breakpoints per linearizer
• The source can be any analog signal
B9 Template Customization
Each template can be customized by changing the sources for various functions in the COMMANDER 350. This
allows math blocks and custom linearizers to be added into the standard template format.
The following sources can be programmed:
• process variable inputs
• set point inputs
• position feedback input
• input to ratio/bias block
• ratio inputs
• bias inputs
• disturbance variable inputs
• input to feedforward block
• feedforward term: add to or multiply with PID O/P
B10 Connecting the COMMANDER PC Configurator
…APPENDIX B – COMMANDER CONFIGURATION EDITOR
Note. The COMMANDER 350 must
be in Configuration Mode (levels 6 to E)
and Modbus serial communications must
be disabled when using the PC
Configurator.
351.5
350.
50
RS232 Serial Port
Fig. B1 Connecting the COMMANDER PC Configurator
To Next Page
Loading...
