92
…5 CONFIGURATION MODE
5.8.1 Digital Output 1
Digital Output 1 (do1) Assignment Source
Select the source required to activate Digital Output 1
See Rear Fold-out/ Table C – Digital Sources.
Digital Output 1 (do1) Polarity
The output can be set to energize for either an active or inactive digital
signal.
POS – Output energized when source is active.
NEG – Output energized when source is inactive.
Continued…
•1 If the output is assigned to a control output by the control type, the setting displayed cannot be changed – see
Section 5.2, Basic Configuration/Control Output Type.
•2 Not applicable if digital output 1 is assigned to a control output.
tYP1
dIG
NONE
dGI.A
C.07
POS
dG1.P
C.08
AN2.A
NONE
•1
•2
C07, C08
To Next Page
Loading...
